View Full Version : new blade
01-06-2001, 02:53 PM
I just recently bought an Easton Ultra Lite. I just broke the blade and need a replacement. As this will be my first attempt at changing a blade, is there anything to watch out for so I don't fry my shaft???
Thanks for any help.
01-06-2001, 05:55 PM
use a heat gun don't use flame. thats about it
01-06-2001, 06:41 PM
USE STREAM TO LOOSING IT
01-06-2001, 09:28 PM
Make sure you haven't just outgrown the stick. I once bought a new blade because my old one was worn down to nothing. I put it in and found out that I needed a new stick, not just a new blade. This is a reason I stick with wood. also, aluminum gets cold when playing outdoors in fall/winter here in PA.
01-06-2001, 10:50 PM
where in PA
01-08-2001, 06:29 PM
Pittsburgh. specificly I play at a local rink and I may play for Fox Chapel highschool, depends on if I have the money for new outdoor skates, seeing as I only have ratty old $50 pieces of junk.
Mario! Mwahahaha!<P ID="edit"><FONT SIZE=-1><EM>Edited by FunkyB on 01/08/01 06:31 PM.</EM></FONT></P>
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.